T. Michel Formenbau GmbH & Co. KGT. Michel Formenbau GmbH & Co. KGT. Michel Formenbau GmbH & Co. KGT. Michel Formenbau GmbH & Co. KGT. Michel Formenbau GmbH & Co. KGT. Michel Formenbau GmbH & Co. KGT. Michel Formenbau GmbH & Co. KGT. Michel Formenbau GmbH & Co. KGT. Michel Formenbau GmbH & Co. KG

cooling system - FOG Jet

 

The cooling system of a mould is also for the stabilization process and the shrinkage of the foam part responsible and should receive attention.

 

The new cooling system, named FOG Jet,  optimize the cooling process in your production process.

 

Your benefits:

  • Save up to 60% of water
  • Mould disassembly for repair isn’t necessary
  • Reduction of maintenance requirements by 90%
  • Maintenance requirement could be do on mounted mould
  • Modification of existing mould without any problems

 

We differentiate between two fitting options:

  • Fitting over a distributor outside of a steam chamber – the spray fog jet nozzles would be therefore through the backsite assembled on the mould.
  • Fitting in steam chamber – the spray fog jet nozzles would be with a special connection block possitioned in a steam chamber.

 

Depending on the article dimensions, we are choosing which kind of spray nozzles is possible for your mould.

 


 

Deutsche Sprachversion English Version